Calico creates a routed network on which your containers look like normal IP speakers. You can connect to them from a host in your cluster (assuming the network policy you’ve assigned allows this) using their IP address.
This document discusses connectivity between Calico endpoints and hosts outside the cluster.
Outbound connectivity refers to connections originating from Calico endpoints to destinations outside the cluster.
The easiest way to get outbound connectivity is to turn on NAT Outgoing on all Calico pools you want to be able to access the internet.
calicoctl get ipPool
For each pool that needs connectivity:
cat << EOF | calicoctl apply -f - - apiVersion: projectcalico.org/v3 kind: IPPool metadata: name: ippool-ext-1 spec: cidr: 192.168.0.0/16 natOutgoing: true EOF
ipipMode: Always if needed]
Please note that many solutions for inbound connectivity will also provide outbound connectivity.
Inbound connectivity refers to connections to Calico endpoints originating from outside the cluster.
There are two main approaches: BGP peering into your network infrastructure, or using orchestrator specific options.
Remember to configure your network policy to allow traffic from the internet!
This requires access to BGP capable switches or routers in front of your Calico cluster.
In general, this will involve peering the nodes in your Calico cluster with BGP capable switches, which act as the gateway to reach Calico endpoints in the cluster from outside.
A common scenario is for your container hosts to be on their own isolated layer 2 network, like a rack in your server room or an entire data center. Access to that network is via a router, which also is the default router for all the container hosts.
See the BGP peering document
for information on how to set up the
calico/node sides of the sessions.
Consult the documentation for your BGP capable switch/router to set up the
switch sides of the sessions.
If you have a small number of hosts, you can configure BGP sessions between your router and each Calico-enabled host. With many hosts, you may wish to use a route reflector or set up a Layer 3 topology.
Calico supports a number of orchestrator specific options for inbound connectivity, such as Kubernetes service IPs, or OpenStack floating IPs.
Consult the documentation for your orchestrator for more information.