Use IPVS kube-proxy
Use IPVS kube-proxy mode for load balancing traffic across pods.
No matter where you are on your journey with container networking, iptables will serve you well. However, if you are scaling above 1,000 services, it’s worth looking at potential performance improvements using kube-proxy IPVS mode.
This how-to guide uses the following Calico features:
- FelixConfiguration with KubeNodePortRanges
Kube-proxy process handles everything related to Services on each node. It ensures that connections to the service cluster IP and port go to a pod that backs the service. If backed by more than one service, kube-proxy load-balances traffic across pods.
Kube-proxy runs in three modes: userspace, iptables, and ipvs. (Userspace is old, slow and not recommended.) Here’s a quick summary of iptables and ipvs modes.
|kube-proxy mode||Designed to be…||Linux kernel hooks||Connection processing overhead…|
|iptables||An efficient firewall||NAT pre-routing using sequential rules||Grows proportional to cluster size|
|ipvs||A load balancer with scheduling options like round-robin, shortest-expected delay, least connections, etc.||Optimized lookup routine||Stays constant, independent of cluster size|
If you are wondering about the performance differences between iptables and ipvs, the answers are definitely not straightforward. For a comparison between iptables (including Calico’s own use of iptables) and ipvs modes, see Comparing kube-proxy modes: iptables or IPVS? .
IPVS mode and NodePort ranges
Kube-proxy IPVS mode supports NodePort services and cluster IPs. Calico also uses NodePorts for routing traffic to the cluster, including the same default Kubernetes NodePort range (30000:32767). If you change your default NodePort range in Kubernetes, you must also change it on Calico to maintain ipvs coverage.
iptables: when to change mark bits
To police traffic in IPVS mode, Calico uses additional iptables mark bits to store an ID for each local Calico endpoint. If you are planning to run more than 1,022 pods per host with IPVS enabled, you may need to adjust the mark bit size using the
IptablesMarkMask parameter in Calico FelixConfiguration.
Calico auto detects ipvs mode
When Calico detects that kube-proxy is running in IPVS mode (during or after installation), IPVS support is automatically activated.
Before you begin…
- kube-proxy is configured to use IPVS mode
- Services for ipvs mode are type, NodePort
As previously discussed, there is nothing you need to do in Calico to use IPVS mode; if enabled, the mode is automatically detected. However, if your default Kubernetes NodePort range changes, use the following instructions to update Calico nodeport ranges to stay in sync.
Change Calico default nodeport range
In the FelixConfiguration resource, change the configuration parameter for the default node port range (
KubeNodePortRange,) in Calico to match your new default range in Kubernetes. For help, see FelixConfiguration.