The Calico data path: IP routing and iptables
One of Calico’s key features is how packets flow between workloads in a data center, or between a workload and the Internet, without additional encapsulation.
In the Calico approach, IP packets to or from a workload are routed and firewalled by the Linux routing table and iptables infrastructure on the workload’s host. For a workload that is sending packets, Calico ensures that the host is always returned as the next hop MAC address regardless of whatever routing the workload itself might configure. For packets addressed to a workload, the last IP hop is that from the destination workload’s host to the workload itself.
Suppose that IPv4 addresses for the workloads are allocated from a datacenter-private subnet of 10.65/16, and that the hosts have IP addresses from 172.18.203/24. If you look at the routing table on a host:
You will see something like this:
There is one workload on this host with IP address 10.65.0.24, and accessible from the host via a TAP (or veth, etc.) interface named tapa429fb36-04. Hence there is a direct route for 10.65.0.24, through tapa429fb36-04. Other workloads, with the .21, .22 and .23 addresses, are hosted on two other hosts (172.18.203.126 and .129), so the routes for those workload addresses are via those hosts.
The direct routes are set up by a Calico agent named Felix when it is asked to provision connectivity for a particular workload. A BGP client (such as BIRD) then notices those and distributes them – perhaps via a route reflector – to BGP clients running on other hosts, and hence the indirect routes appear also.
The routing above in principle allows any workload in a data center to communicate with any other – but in general, an operator will want to restrict that; for example, so as to isolate customer A’s workloads from those of customer B. Therefore Calico also programs iptables on each host, to specify the IP addresses (and optionally ports etc.) that each workload is allowed to send to or receive from. This programming is ‘bookended’ in that the traffic between workloads X and Y will be firewalled by both X’s host and Y’s host – this helps to keep unwanted traffic off the data center’s core network, and as a secondary defense in case it is possible for a rogue workload to compromise its local host.
Is that all?
As far as the static data path is concerned, yes. It’s just a combination of responding to workload ARP requests with the host MAC, IP routing and iptables. There’s a great deal more to Calico in terms of how the required routing and security information is managed, and for handling dynamic things such as workload migration – but the basic data path really is that simple.